Skip to content

Check parts on arrival

Do this the day the parts arrive, while you can still return them. Record the result (pass or fail and why) in the build record. A part that fails receiving inspection never goes into a robot.

Every part

  • [ ] The part number on the part matches the order and the BOM.
  • [ ] No transport damage: cracked housings, bent pins, crushed corners on the box.
  • [ ] Note the lot or batch number if there is one (photo of the label).

Electronics

Part Check Fail if
ZED-F9P GNSS board The u-blox module's laser marking is sharp and the board maker's name is printed on the PCB; connect it over USB and read the firmware version Blurry or printed (not etched) marking; module reports an unknown or odd firmware
Raspberry Pi 5 Boots from a known-good card; vcgencmd get_throttled reads 0x0 with the official PSU Doesn't boot; throttling with the official PSU
IMU (BNO085) Detected on I²C at address 0x4A or 0x4B Not detected; wrong chip ID
Fuses Rating printed on the fuse matches the wiring drawing; the body is the brand you ordered Missing or smudged rating; a different brand to the listing
STOP button Pressing latches it; twisting releases it; contacts open when pressed (measure with a multimeter) Doesn't latch; contacts close instead of open (wrong type: must be normally closed)

Batteries

Lithium batteries

Inspect batteries outdoors or on a non-flammable surface. Never charge a pack that is swollen, dented, warm, or smells sweet. Put it in a metal box outside and contact the seller.

  • [ ] No swelling: the pack sits flat and the case isn't bulging.
  • [ ] Open-circuit voltage is within the "storage" range for its chemistry (for a 7S Li-ion pack, about 25–27 V; the full range is 21–29.4 V). Below 21 V: don't charge it.
  • [ ] The connector matches the wiring drawing, and its polarity is right (measure; don't trust wire colours).
  • [ ] The BMS label and UN38.3 paperwork are present.

Mechanical (H2: a used mower)

  • [ ] Wheels turn freely by hand with the motors unplugged; no grinding.
  • [ ] The blade disc and guard are intact: no cracks, nothing bent.
  • [ ] The rain seals are present and not perished.
  • [ ] The dock's contacts are clean and springy.